|
|
#18
19-07-09, 21:48
|
||||
|
||||
right unfortunately i have found that the drawings above are not correct to a 1942 Mk1 canadian carrier specification. i am going to have to go on a road trip to see a pucker mk1 methinks !
i measured my armour remnants and came back with the following so on my 1942 canadian UC Mk1 rear and side armour plate is 8mm front armour is 10mm Glacis plate 5mm center bulkhead 5mm good news is that i have DXF'd most of the plates so once i change the parameters they should be ok for CNC use
__________________
is mos redintegro __5th Div___46th Div__ 1942 Ford Universal Carrier No.3 MkI* Lower Hull No. 10131 War Department CT54508 (SOLD) 1944 Ford Universal Carrier MkII* (under restoration). 1944 Morris C8 radio body (under restoration). Last edited by RichardT10829; 19-07-09 at 21:56. 
|
|
|
Threaded Mode