|
|
|
|
#1
17-03-10, 15:52
|
||||
|
||||
I would like to put a 6 cyl diesel but the problem is the size of those engine!
The only one i think should fit is a new 1106D perkins 36 inch long but i think it has an ECM. The CUMMINS 6BT is +- 41 inch long dosent fit without BIG modification! 
|
|
#3
23-03-10, 17:27
|
|||
|
|||
|
Locking gas caps.....
Standard size available at Canadian Tire....
If you are looking for the large M37 gas cap....... NIX...... you will need to build your own with a small metal strap welded on the side of the truck box and padlock...... carefull welding above the open gas tank opening....! May be easier to lock up the kids....... Tried looking up cylinder sleeves..... Nylen used to make them for Chev engines but do not seem to be existing under that name...... lots of sleeves available for expensive Diesel rebuilding but very little for old gas engines. May also be very difficult to find a machine shop willing to tackle an engine they are not familiar with or set up to work on a 50 years old engine. I would search for a mchine shop that specializes in rebuilding older gas engine for farm tractors........ the 251 was used by Massey Ferguson tractors and combines. Boob
__________________
Bob Carriere....B.T.B C15a Cab 11 Hammond, Ontario Canada
|
|
#4
23-03-10, 19:04
|
||||
|
||||
|
I no that stant makes many locking gas cap but the problem is thay dont say wath size thay are!
I think y will modifie one of stant so it could fit on it! I cant lock up the kids its the nabers   I will send a message to sealed power i no thay make cylinder sleeve. may be able to match them!
|
 |
|
|
Hybrid Mode
