JEEP willy's help

[Speedy]

Originally Posted by Geoff Winnington-Ball

If the pistons are frozen then the chances are good that the valve train is too. You'd best remove the head, inspect it and the valves for damage/pitting, then soak the cylinders until you can hand-crank the engine. Don't overdo the force in hand cranking as you'll risk damaging stuck valves as well. Once everything is moving, you can have a good look at the cylinder walls and decide at that point whether it might be better pulling the engine and sending it out for a rebuild... which may well be what's needed; if there's damage in the upper end, it's most likely the crank needs inspecting/grinding/new bearings as well. Better to do it now while you're in rebuild-mode!

Geoff

hi Geoff.

that is what I was worried about, if the pistons are stuck, the valves may be also, and if I start the engine it may backfire allot and possibly create more damage.

I think I can do all the labour of tearing down assembling the engine, and leave the machining to the engine guys.

I guess it would be good to get hardened valve seats in the engine at that point.

I am sure allot of guys here have redone their engines, does anyone have a idea of what it can cost me?

and lastly, anyone have an idea of how I should plan out my attack to re doing this vehicle?
would the engine be last? drivetrain first? then body?