![]() |
|
#1
|
||||
|
||||
![]()
Hi Paul,
Nice works on the truck and i see you ave rogers cable service Nice ![]() For your compressor you should have a water removal systeme install because you compressor is in your basement and the air is cold and moisty and the compressor will be run in hot the water will be hig in your systeme if you need pic i could show you my systeme wit water free at the end ![]() ![]()
__________________
Eric Thibodeau 1942 willys Jeep |
#2
|
|||
|
|||
![]() Quote:
they are not expensive and available at most air conditioning or plumbing wholesaler.. This is one but the price at $85.00 is about double or triple of what I used to pay for a 1/4NPT auto blow down.. And this one dosen't have a timer on it.. https://www.pieco.ca/catalog/pieco_l...06982#I0006982 Check with Home Depot or where ever you got the IR Compressor... Schooner Supply is the big IR supplier in your area..If you have a problem locating one at a good price..PM me and I'll get you in touch with the right people to get that for your IR compressor..or any other stuff you may need for it.. Alex
__________________
Alex Blair :remember :support :drunk: |
#3
|
|||
|
|||
![]()
i have a dehumidifier running full blas rigth next to the compressor, so far everytime i drain the thank there was no condensate in it, lucky i guess,lol
|
#4
|
||||
|
||||
![]() Quote:
![]() ![]()
__________________
Eric Thibodeau 1942 willys Jeep |
#5
|
|||
|
|||
![]()
ets start with last friday! i did some happy neigbors prevention, i got a tent garage to hide the m37 inside, it will provide shelter for the truck and me when it rains and it look better in the yard so the niegbor wont have the time to complain about the state of my yard!
and then today i cleaned up a bit in the shed then i chased the tread on the hardware from the frame, i also had the time to clean and etch the four remaining frame hook anyhow here are the pictures of the day enjoy! the m37 shelter! ![]() the tidy yard...somewhat! ![]() the new clean painting place ![]() the bolts that where chase and some hardware ready to be cleaned ![]() the rest of the hardware, i am not reusing the original tie's for the wiring and lines, and i cant remember what are the two bracket on the rigth ![]() and the frame hook ready to be painted! ![]() paul |
#6
|
|||
|
|||
![]()
well today i got the hardware from the frame clean, the i started on the removable crossmenber for the transfert case, the hardware was chased and cleaned and the i started on derusting the crossmember , an old friend showed up and i quit for the day!
anyhow here are the pictures of the day, enjoy! etched bracket ![]() more hardware ready to paint ![]() and i started on the crossmember! ![]() paul |
#7
|
|||
|
|||
![]()
well today i got the crossmember ready for paint, and i started on the pintle hook, part of it is ready for paint and the rest will get done next week, i had enuf heat for this week, lol i hate summer!
anyhow here are the picture of the day, enjoy! crossmember ready for paint! ![]() more hardware ready for paint ![]() and the rest of the pintle hook ![]() paul waiting for autum in beresford! |
![]() |
|
|