![]() |
|
#1
|
||||
|
||||
![]()
The boxing and mesh have been in place for two weeks, the sun came out today so I pored the last slab for the drain. I had a good run two hours to mix seven and a half bags of cement and clean up.
![]() Vicki will finally be able to garage her car again next week ![]()
__________________
Robert Pearce. |
#2
|
||||
|
||||
![]()
The drain works well no water through the garage lately which is a releaf as the storms have been heavy lately.
The last couple of days have been spent building a roof over the caravan spare room, the wind this year has shreaded 2 polly tarps that were tied tightly over the van so while the brother in law was out for a break we decided a more permanent cover was needed. ![]()
__________________
Robert Pearce. |
#3
|
||||
|
||||
![]()
It's nice to get a job around the house that you don't mind doing ocasionally.
![]()
__________________
Robert Pearce. |
#4
|
||||
|
||||
![]()
On the strength of the last cattle sale we are going to get the first two bays of the BBQ area concreted soon so today I wired up some lights. I installed the sensor light on the garage and two LED flood lights in BBQ area, two more LED's are mounted and most of the wire is run for them.
![]()
__________________
Robert Pearce. |
#5
|
||||
|
||||
![]()
First two bays now wired and all lights work. When the other bays are wired in the future there will be twice the wire in the box.
![]()
__________________
Robert Pearce. |
#6
|
||||
|
||||
![]()
I cleaned out the surplus clay getting ready to concrete the first bay today. I was having fun plying with the backhoe so decided to start puting new colvets in the drive so I can form up a decent road into our house, now I will have to test my welding skills as the end pulled off the main lifting ram
![]()
__________________
Robert Pearce. Last edited by hrpearce; 26-04-11 at 20:33. |
#7
|
||||
|
||||
![]() Quote:
![]() Just keep smiling ![]()
__________________
Richard 1943 Bedford QLD lorry - 1941 BSA WM20 m/cycle - 1943 Daimler Scout Car Mk2 Member of MVT, IMPS, MVG of NSW, KVE and AMVCS KVE President & KVE News Editor |
![]() |
|
|