|
|
|
|
#1
03-09-10, 15:34
|
||||
|
||||
Great thanks for the pics, I've know what i've got to fab up now
__________________
Cameron Reed, AKA Chopper 
|
|
#2
22-09-10, 16:42
|
||||
|
||||
|
repairing the shaft
Hi there, I just thought that I would share with you the way that I repaired the broken shaft of my compressor. I decided that I would make a new extention and butt weld it on to the old shaft, mainly because I couldn't free the shifter fork off the old one, and didn't want to risk trying to heat the fork (looks like it's die cast) and end up with a blob on the floor!
Photo 1 a piece of 1"x1/2" turned on a mandrel (3/8" bolt) roughing out Photo 2 after linishing to final shape Photo 3 setting up to weld in some angle about an 1/8" gap to weld right through Photo 4 1st run in check alignment Photo5 finished weld just got to linish back to flush so gland nut can come down Photo 6 on and working fine time for a Bundy can 
__________________
Cameron Reed, AKA Chopper
|
|
#3
22-09-10, 16:44
|
||||
|
||||
|
Photo
my oops could only get 5 in so here's no 6 all the best
__________________
Cameron Reed, AKA Chopper
|
 |
|
|
Hybrid Mode
