|
|
#4
25-01-11, 00:45
|
|||
|
|||
question answered
Hello Mike and Terry
Mike you understood my question, thank goodness. I noticed in the photo, outlines of a patch over where the large hole would be. I went back to the operators manual and took a look at the photo and sure enough the original had a patch spot welded over the larger hole and then a small hole for the wires drilled into this patch. Therefore my question has been answered. Thanks Terry i still owe you a visit. Eric
__________________
Collecting data on the WW2 Canadian jeep and trailer. Serial, WD Numbers etc. 
|
|
|
Threaded Mode