Quote:
Originally Posted by derk derin
Rob,
I am only going to concentrate on my later production bike as it has the most original parts on it.My early bike has only the frame and front forks original so it is a long way from being completed.Did you get your crank off?Was it a reverse thread to get the locking nut off?
Derk.
|
The reverse thread was only on the bearing cup underneath the sprocket. On the adjusting side, both the lock collar and the bearing cup were right hand thread.
I wish I had known more about bikes. I found out the hard way that once the left crank is off, you can drive the shaft off the right crank and through the hub. I was trying to pull the crank off the shaft.....a lot harder to do.
Supposed to warm up to 0 this weekend so I'll be able to run the compressor and sandblast the frame and accessories.
10-02-11, 04:36
Threaded Mode