|
|
#7
22-02-11, 16:24
|
||||
|
||||
I beleive that central hole on the bottom of the bin was only intended to be on the R.S. bin. The wireless installation instructions show that a hole needs to be drilled there so that a cable clip can be bolted underneath.
As for attaching the felt to the wood in the lid, I used the split rivets as shown. I did the head of the rivet in the felt and pushed the legs through the plywood. The two of them held the felt on very well.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer 
|
|
|
Threaded Mode