|
|
#25
10-04-11, 18:45
|
||||
|
||||
yes i do want to do it, i was going to ask one of our Canadian cousins or someone on our rock to take a rubbing on grease proof paper for me (for each pannel) then tape this to the plate and hammer a special chisel i am making over each mark until the entire plate is done
as for the rivets the bottoms ones you see are screw type as per previous discussions... however a pal of mine as a chicago pneumatic rivet gun so i may go back to solid riveting pending on a few things i have to iron out as yet. i can turn the rivets out quickly on the lathe drilling them then running an m6 tap down them. The lathe i had access to was at a college and they are running night classes now so cant get access again (hence my advert wanting a lathe)
__________________
is mos redintegro __5th Div___46th Div__ 1942 Ford Universal Carrier No.3 MkI* Lower Hull No. 10131 War Department CT54508 (SOLD) 1944 Ford Universal Carrier MkII* (under restoration). 1944 Morris C8 radio body (under restoration). 
|
|
|
Threaded Mode