Fixing a common cab 12 design problem

[Ganmain Tony]

On my beast Keefy, it almost started happening straight away. I attribute it to the fact the cab is bolted rigid to the Chassis. A massive improvement was acheived in changing this in the Cab 13 design.

Any movement over bumps and the poor old thing sounds like a square rigged ship of the line in Nelsons Column...

It may also have been exacerbated by the excursion I had into a table drain when I came around a blind corner on a dirt road at 70 km/h and discovered I was at a T intersection.

The ensuing bump when the front wheels touched ground again caused suprisingly minimal damage, but they did cause those two timbers to come loose at that left hand windscreen corner.

Ive seen some impressive mods including the entire frame replaced with metal and welded to resemble the hull of a T34.

But in the end, they all seem to come apart