|
|
#3
11-02-12, 16:12
|
||||
|
||||
Hi, Made three cooker trays, got a drawing from a member on here and borrowed the remains of a canadian tray. The feet i have confirmed are not 10 gauge as in the attached draw but 12g 2.5mm approx. I have also noted the batten with the cut out only has two screws holding it to the tray, the centre one was never there. Also the drawing indicates the four centred tray holes are drainage, this is incorrect as can be seen from the original four n08 1/2" round head screws were used to secure what i think is a 9" square 1/2" plywood. I am unable to determine if a drainage hole was positioned elsewere as the original is a little rusted out.
17 x 7/8" no8 countersunk. 4 x 1/2" no8 roundhead. Thanks to everyone who helped, kev.
__________________
2pdr Tank Hunter Universal Carrier 1942 registered 11/11/2008. 3" Mortar Universal Carrier 1943 registered 06/06/2009. 1941 Standard Mk1 stowage Carrier, Caunter camo. 1941 Standard Mk1 stowage Carrier, light stone. 10 cwt wartime mortar trailer. 1943 Mk2 Daimler Dingo. 1943 Willys MB. 1936 Vickers MG carrier No1 Mk1 CMM 985. 
|
|
|
Threaded Mode