2012 at the Hammond Barn

[Gunner]

Hi Kris: Your also welcome to check out the Swords and Ploughshares Museum when the snow is gone!

Cheers! Mike

[Bob Carriere]

So I see you have migrated from hot kitchen to hot air heating......

Your hulk is still parked at the back eagerly waiting your gentle touch or is it torch.

Drop by the barn remind yourslef how big the CMPs are...... Height is likely the major issue if you plan to instal a standard garage door. Having to bolt up and remove your cab top every time you go in and out can be a bitch.

Don't forget the Plasma will require a compressor...... and both the compressor and the plasma cutter will require amps..... hope you anticipated that in your E panel change over. The Mig welder has probably more frequent use than the plasma cutter....... Oxy-acet torches is also important for heating/loosening nuts, bending/straightening and cutting.

Apparently Spring is coming..... do drop by the barn on weekends.

Bob