![]() |
|
#1
|
||||
|
||||
![]()
this is not our deck.
our deck only have the 2 exhaust covers,and on the right side against the rear armour plate a little bracket in the corner. what i need is the measurements from the 2 brackets and the bracket for the lifting jack,also the the right position were fitting them. roy |
#2
|
||||
|
||||
![]()
Hi, Here is a picture drawn of the two brackets for retaining the jack, also the centre boys tripod/monopod bracket, also details of the rear battery box rod support strip bracket and ration tray strap retaining stud. The jack brakets are easy to make from one piece folded steel. attached are the ones i made. I have since come by some original brackets but they are no different to these. Have not got dimensions of were they are located on the rear deck at the moment.
kev.
__________________
2pdr Tank Hunter Universal Carrier 1942 registered 11/11/2008. 3" Mortar Universal Carrier 1943 registered 06/06/2009. 1941 Standard Mk1 stowage Carrier, Caunter camo. 1941 Standard Mk1 stowage Carrier, light stone. 10 cwt wartime mortar trailer. 1943 Mk2 Daimler Dingo. 1943 Willys MB. 1936 Vickers MG carrier No1 Mk1 CMM 985. |
#3
|
||||
|
||||
![]()
kevin very helpfull pics
![]() and i like the picture draawn very much. thanks for it. only the big bracket for the lifting jack and i have everything i need. |
#4
|
||||
|
||||
![]()
the little bracket in the right front corner is for the starting handle and goes from the left too the rear all over the deck behind the jack brackets?
|
#5
|
||||
|
||||
![]()
Hi, I have a detailed drawing for the jack block holder, i will post it in the next 3 days, I not sure what you ment in the post previous to this one??.
kev.
__________________
2pdr Tank Hunter Universal Carrier 1942 registered 11/11/2008. 3" Mortar Universal Carrier 1943 registered 06/06/2009. 1941 Standard Mk1 stowage Carrier, Caunter camo. 1941 Standard Mk1 stowage Carrier, light stone. 10 cwt wartime mortar trailer. 1943 Mk2 Daimler Dingo. 1943 Willys MB. 1936 Vickers MG carrier No1 Mk1 CMM 985. |
#6
|
||||
|
||||
![]()
on the rear fender right side is a little bracket mounted against the rear armour plate,(on the picture it is damaged)
|
#7
|
|||
|
|||
![]()
If you are talking about a little bracket that forms a small box, that is for the end of the engine crank. It runs the width of the carrier, and the handle is stowed on the left fender.
|
![]() |
|
|