|
|
#1
24-04-12, 19:12
|
|||
|
|||
Could some help identify these carrier parts?
Could some kind soul look up these part numbers for me? I no longer have a UC parts list. I recognise some of them, but could do with the actual part names if someone can help. The part in the photos I do not recognise and it has no part number on it.
The parts are as follows: CTL 13054 CTL 13250 CTL 14125 CTL 14169 TL 13270 Kind regards Paul Last edited by gunnerop; 24-04-12 at 19:18. 
|
|
#2
24-04-12, 20:14
|
|||
|
|||
|
P/N from FUC-03
CTL 13054 handgrip, front protection plate - left See Ill 44
CTL 13250 bracket - gear shifter guide CTL 14125 handgrip and BREN gun support CTL 14169 protector-L.H. front bell crank TL 13270 clip - tripod clamp
|
|
#3
24-04-12, 21:49
|
|||
|
|||
|
Michael,
Thanks very much for the quick response and confirmation of the correct part names. I knew what some of them were, bit of a no brainer as regards the handgrip especially as one of them still has the 'jesus' handle attached. Anyone care to have a go at the part in the photos? Thanks again. Paul
|
|
#4
26-04-12, 11:18
|
|||
|
|||
|
Paul
It must have a part number.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions....
|
|
#5
26-04-12, 12:48
|
|||
|
|||
|
Hi Lynn,
Just been over it again with fine wire wool, just to save any embarrassment on my part! No sign of any part number unless they did something stupid like stamping it where the strap is riveted to the back plate. Just to be clear this is a small part (the backing plate is 2¼" square approx) It has a folded lip above the single mounting hole (3/8" dia) so it seems it was meant to locate on the corner of something. The strap is ¾" width. Known to have come off a carrier, but not which Mk unfortunately. Cheers Paul
|
 |
|
|
Linear Mode
