|
|
#27
09-05-12, 02:57
|
|||
|
|||
Looks good Phil
....one word of caution....
When building the ramp..... the front separate rectangualr section is a bit short in the flat area...mine was 18 inches plus 2x 2 inch tube cross section for a total of 22 inches........ I would strongly recommend at least 4 preferrably 6 inches longer if you intend to use a 20 inch tire..... because when you remove the back ramp section it is a bit short...... Meanwhile will look forward to the plan or sketch of your engine stand and some explanation of the rear (adjustable ? ) engine support to the bell housing. I am gradually collectig supplies for my rotisserie..... Bob
__________________
Bob Carriere....B.T.B C15a Cab 11 Hammond, Ontario Canada 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2015 at the Hammond Barn | RHClarke | The Restoration Forum | 113 | 31-12-15 21:00 |
| 2013 at the Hammond Barn | RHClarke | The Restoration Forum | 85 | 05-01-14 23:29 |
| 2011 at the Hammond Barn | RHClarke | The Restoration Forum | 328 | 01-01-12 21:09 |
| 2009 at the Hammond Barn | RHClarke | The Restoration Forum | 322 | 02-01-10 16:05 |
| Hammond Barn Visit | Wpns 421 | The Softskin Forum | 1 | 15-12-09 03:17 |
Threaded Mode