M3A1 AOP Scout Car Armour

[Big D]

Gidday,

Merry Xmas to all.

I have managed to ‘wing’ this and think I have all the measurements correct now on a new sketch diagram right bar one.

I am after confirmation of the measurement from the two outside skate rail mounting holes to the next set of four skate rail mounting holes. That is, on the sketch above, the set of two holes that are marked as being 2.875” from the right side; to the set of four holes marked as being 10.625” from those holes.

I believe this latter measurement is the one that is not right on this diagram I have. The diagram I have suggests this measurement should be 10.625”. I suspect the true measurement should be closer to 12 5/8”.

Can any Scout Car owners out there oblige please?

Cheers

Darryl