|
|
#6
13-05-13, 12:14
|
||||
|
||||
I thought so, based on the content similarities
 Rob, do you know if there is a "collar" kit to mount the common bell crank on that CDN2 mount? This is a picture of the mount with the collar (heavy tin with a spring inside and seal) from inside the top of the existing bell crank pushed on. With this the common crank seemed to fit fine. This looks like it would bring up the crank and change the angle so maybe the tie rod would fit. Its not something I can make unfortunately. I hate to do it as I was keeping it stock, or more correctly "last used" I guess, and what is on it is perfectly usable but I do need that tie rod end addressed :-( Thanx again Warren
__________________
1967 M38A1 CDN2 CFR: 67-07929 Stock and "mostly there" https://www.dropbox.com/sh/lbud60opzbv0aug/6OIkoCg_Fs 
|
|
|
Threaded Mode