White M3A1 AOP Windshield and Door armour

[Hanno Spoelstra]

Originally Posted by motto

The differences between the White Scout Car and Half Track armour can probably be explained by differences in the mechanical components used on the two vehicles. Larger engine needed larger engine bay. Tracks instead of wheels on the rear may have dictated a wider hull. Length of track unit meant longer arches resulting in narrower front doors (about 6" from memory).

I would be fairly sure that's what it's about.

David,

Thanks, sure makes sense. Looks can be deceiving! Just like the Chev and Ford CMP, they look they same - but the differences are actually quite significant.

Hanno

[motto (RIP)]

Darryl, if you PM your email address I will try to get you the wiper slot photo. I also have a camera problem that will delay things a little.

To describe things a bit better re the wiper slot:- Starting with the blank plate drill a 1/2"diameter hole with the centre 3/4" up from the lower edge. That creates the upper end of the slot. Next, counterbore that hole from the rear face 7/8" diameter X.230 deep. Lastly, remove just enough material to create a 1/2" wide slot from the original 1/2"hole to the lower edge. Job done! DO NOT EXTEND THE COUNTERBORE.

David

[Big D]

Hi David

PM sent, thanks.