White M3A1 AOP Windshield and Door armour

[motto]

Good upon you Ghostly Robert, the photos are exactly what was needed and were a problem for me to supply.

Darryl, The only door upper armour I have has been modified along the upper edge but I will give what dimensions are useful.

The lower edge is 33-3/8" long the same as the upper edge of the door itself.
The view port is 8" X 3-1/2" and is at an angle of 18 degrees from the horizontal (as best as I can measure).
If a line is extended from the lower edge of the opening in both directions the rear extension will intersect the lower edge 19-1/8" from the forward corner. The forward extension will intersect the sloped forward edge 6-1/8" up from the forward corner.
A line drawn through the centres of the aft block guide mounting holes measures as being 1-1/8" aft of the rear edge of the opening with the hole centres 1-11/16" and 6-11/16" up the line from the lower edge.
Forward guide mounting hole centre line is 1-3/4" forward of forward edge of the opening with hole centres 4-3/8" and 10-1/2" up the line from the lower edge.

There is not much more you may need that I can give you Darryl but don't hesitate to ask.

David

Oops, need to locate view port in fore and aft direction!