|
|
#11
05-08-13, 11:30
|
|||
|
|||
backing plates back on
Moved on to adjusting the RH backing plate with my die grinder, enlarged the hole slightly so that the backing plate would fit over the actuator shaft in the mounting plate.
Fitted the backing plate and also fitted the LH brake drum as I managed to paint it earlier in the week when the weather was good. Finished fitting the exhaust elbows into the hull floor, then moved on to the exhaust pipes (had these cut & bent by exhaust shop) and creating the Y section outlet.
__________________
1943 Ford GPW Jeep "Follow Me" 1943 MBT trailer 1943 Dodge WC-57 Command Car 1943 Chev C60L Army Cargo Truck 1941 LP2 VR 731 Bren Gun Carrier 3" Mortar Carrying Under restoration: 1940 LP1 Bren Gun Carrier 194? 1 Ton Trl Ben Hur 1942 C15A with sunshine cabin MVPA 31338 
|
|
|
Threaded Mode