|
|
|
|
#11
05-11-13, 04:27
|
|||
|
|||
Right hand single station has been out for a week detailed painted and back in as of today . There are two bolts that bolt the support to the engine rails which are in ! But I notice there are two holes just inside the backing plate on the floor where the support comes through the hull sides I can't find any info in the books on these two should these have bolts as well if so should the nuts be on the inside and bolts up through the hull floor ? Dale
  
__________________
1944 GPW and Bantam trailer Last edited by Dale Jordan; 05-11-13 at 04:37. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vic rail 2225 | colin jones | The Carrier Forum | 109 | 13-07-13 15:15 |
| My GM engine number when was it build?? | 8threcce | The Restoration Forum | 7 | 09-01-12 08:39 |
| Iltis carb re-build kit | servicepub (RIP) | Post-war Military Vehicles | 2 | 15-05-11 22:33 |
| How To Build A 2/5 Sherman Tank | T.J. | The Armour Forum | 1 | 16-01-08 11:17 |
| Pssst... want to build a gun tractor? | Keith Webb | The Softskin Forum | 12 | 16-07-04 00:13 |
Lynn Eades 
Threaded Mode