|
|
|
|
#1
15-11-13, 13:31
|
|||
|
|||
You guys have forced me to look more carefully, and the parts book backs up what you say.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... 
|
|
#2
15-11-13, 14:23
|
||||
|
||||
|
..
I like parts manuals...
__________________
Charles Fitton Maryhill On., Canada too many carriers too many rovers not enough time. (and now a BSA...) (and now a Triumph TRW...)
|
|
#3
15-11-13, 21:08
|
|||
|
|||
|
Charlie, as the owner of many carriers, can you confirm that they have 2 bends, how far from each end, and what the angles are? (we are talking about CTL 7111)
On another note, when I was at Colins he had a clutch arm (TL 2731 ) it took the standard pin to locate it, but was also clamped tight with a pinch bolt. I hadn't seen one like that before. Are they common?
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... Last edited by Lynn Eades; 15-11-13 at 21:16.
|
|
#4
16-11-13, 12:27
|
||||
|
||||
|
...
standard pins and cotters on mine ( I think ).......
If all goes according to plan , I'll be pushing and pulling things about this afternoon and will look then. Maybe even make a photographic rendering. I'd do a charcoal sketch but it's hard to mail a cave wall.
__________________
Charles Fitton Maryhill On., Canada too many carriers too many rovers not enough time. (and now a BSA...) (and now a Triumph TRW...)
|
|
#5
17-11-13, 16:31
|
||||
|
||||
|
One cavwe wall...
Lets see how this goes: (from a carrier hull on its way to a new home...)
The tape was hooked over the end of the clevis as shown in pic 3... from the bulkhead end , the first bend is at about 18" the matching bend is at the rear clevis total offset is about 2" and of course the axis pins are parallel...
__________________
Charles Fitton Maryhill On., Canada too many carriers too many rovers not enough time. (and now a BSA...) (and now a Triumph TRW...)
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| C60L Unpacking & Assembly Instructions Boxed MUP | Rolf S. Ask | The Softskin Forum | 15 | 10-02-22 14:31 |
| My first carrier: some assembly required | super dave | The Carrier Forum | 207 | 24-03-17 22:52 |
| Flathead assembly | Keith Webb | The Restoration Forum | 6 | 22-09-08 01:11 |
| US vehicle assembly | David_Hayward (RIP) | The Softskin Forum | 0 | 14-09-05 22:21 |
| CMP Assembly | servicepub (RIP) | The Armour Forum | 8 | 27-06-04 17:20 |
Hybrid Mode
