|
|
|
|
#1
17-11-13, 09:43
|
||||
|
||||
Quite a simple part to make when you get into it. These days I really only use a 5"grinder and I do go through a lot of 1mm cutting discs and 40grit flap discs.
|
|
#2
17-11-13, 09:45
|
||||
|
||||
|
The front is now welded in place and just needs some tidying up and a lick of body filler before painting. I got a few dings and dents to fix.
 Colin. Last edited by colin jones; 19-11-13 at 12:47.
|
|
#3
19-11-13, 04:49
|
||||
|
||||
|
The back is a bit too far gone for a patch up, so again I've made a very crude and unattractive pair of press die's!
|
|
#4
19-11-13, 04:52
|
||||
|
||||
|
Of course if the panel never had the pressings then I would have repaired it and the rusted area is right on the press
|
|
#5
19-11-13, 04:55
|
||||
|
||||
|
Rather than make another set which I probably won't use again, I cut the first one down and welded it back at the correct shorter length I needed.
It has stretched a bit here and there but I think I can fix that problem. Colin.
|
|
#6
19-11-13, 05:15
|
|||
|
|||
|
So you made the matching dies and showed the finished product, but where is the middle step, pressing out the ribs?
__________________
Terry Warner - 74-????? M151A2 - 70-08876 M38A1 - 53-71233 M100CDN trailer Beware! The Green Disease walks among us!
|
|
#7
19-11-13, 07:53
|
|||
|
|||
|
pressing
See 24 pic 5
__________________
macca C15 C15A
|
 |
|
|
Hybrid Mode
