|
|
|
|
#1
17-11-13, 16:31
|
||||
|
||||
One cavwe wall...
Lets see how this goes: (from a carrier hull on its way to a new home...)
The tape was hooked over the end of the clevis as shown in pic 3... from the bulkhead end , the first bend is at about 18" the matching bend is at the rear clevis total offset is about 2" and of course the axis pins are parallel...
__________________
Charles Fitton Maryhill On., Canada too many carriers too many rovers not enough time. (and now a BSA...) (and now a Triumph TRW...) 
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| C60L Unpacking & Assembly Instructions Boxed MUP | Rolf S. Ask | The Softskin Forum | 15 | 10-02-22 14:31 |
| My first carrier: some assembly required | super dave | The Carrier Forum | 207 | 24-03-17 22:52 |
| Flathead assembly | Keith Webb | The Restoration Forum | 6 | 22-09-08 01:11 |
| US vehicle assembly | David_Hayward (RIP) | The Softskin Forum | 0 | 14-09-05 22:21 |
| CMP Assembly | servicepub (RIP) | The Armour Forum | 8 | 27-06-04 17:20 |
Hybrid Mode
