variometer mounting

[kevin powles]

Originally Posted by Johnny Canuck

It would appear that a special mounting bracket is required for a Universal Carrier installation.
The Packing Piece No.1 (wood, rubber, bakelite) and a Seating Plate Metal are required. These are fastened to the Variometer with 3 screws ( the 3 holes are visible on the underside of the Variometer case)
The problem is how to fasten this assembly to the vehicle as you can not reach the mounting screws once the Variometer is attached to the plate assembly.
A Brackets, Metal, Mounting, Variometer No.C1 (ZA/Can 1376) is required to mount it to the Vehicle.
This bracket is just visible as the hashed line behind the Variometer in the picture you posted.

Geoff

You need items 2, 27 and 28

Hi, Does anyone know where I can get the top two straps (item 10) of the featured drawing, also the 6 pin dog bone.

thanks kevin.

[Jordan Baker]

I had to buy an extra one of the linfer straps and cut it down. Was simple to pop off the rivets and shorten it.

[Chris Suslowicz]

Originally Posted by kevin powles

Hi, Does anyone know where I can get the top two straps (item 10) of the featured drawing, also the 6 pin dog bone.

thanks kevin.

Item 10 is declared as "Carriers, Set, No.22", which may just be the metal frame. The set retaining strap is the same length as the longer strap in the No.21 or No.23 carriers, but the one for the supply unit is somewhat longer than the supply unit mounting strap for those carriers (as the supply unit fits on top of the set - using the same steel angle strips as used on Carrier 21 or 23 (screwed into the flat plates on the set top)). You may need to cut a longer strap down to make the supply unit mounting strap.

The strap lengths are listed in the Parts Identification section of the EMER, but I'm not sure what the length actually represents! (Just the canvas bit, from the studs to the strap-end of the thread, or the overall length of the whole thing.)

Chris.
(Carriers 1, 2 & 3 were renumbered 21,22 & 23 at some point, 24 is for the WS22 (I think) and 25 is an all-steel carrier for a demountable WS19 used in vehicles (similar to the No.3/23 wooden board type but shorter and with a single very long strap that goes around set and supply unit, plus a plate on top of the set to carry the variometer, an aerial base and a control unit. I'm still looking for the supply unit adapter plate for this carrier.)

[kevin powles]

Hi , Many thanks for the info, it appears all very complicated and the line drawings shown are not that clear, what I really need is a few pictures of what a correct bren gun carrier radio mount, strap and brackets assembly looks like in situ, I will post a picture of the radio trays I have currently, they both came out of carriers and look correct.

Regards Kevin.