Water in the oil

[Little Jo]

Hi Guys

Well I am ready to fit the Cylinder Head back on. So far I have replaced the old Thermostat with a new one and a new retainer. I have also replaced the original bolts with new studs. (See Photos). I had a look at my new cylinder Head Gasket, which is sealed and Silver in colour. It is a 17446.01 Gasket head -L-head type. There is a printed note in 3 languages inside which state.

CAUTION
* The surface of this head gasket has been treated with a coating for better sealability.
* DO NOT use any chemicals or sealers. It must be installed dry.

I have not come across this before as everyone is telling me to spray a copper coating sealant on the metal side before replacing the head. My Question is, do I follow the enclosed instructions that came with the Head gasket, or do I go ahead with the copper spray sealant. Have any of you guys out there in MLU land come across a similar scenario.

PHOTOS.
1. Prepared head ready to put back on.
2. Cleaned up top of the block showing new Studs.

I do want to do the right thing and have no more leaks. Thanks guys.

Cheers

Tony