|
|
#11
13-06-14, 12:20
|
||||
|
||||
Flathead radiator tubes
20140613_190009.jpg 20140613_190033.jpg
My upper radiator tubes arrived today. Nice stainless steel. Shame I will be cutting them apart, on one end. They don't look it in the photos, but the bend is 90 degrees. Should be about 45, as close as I can tell. I have a welder lined up to TIG them back together after I cut them apart. Could someone please confirm exact angle of the end piece? I have nothing here to go from, apart from a couple of well aged rubber hoses which I wouldn't trust to be accurate.
__________________
Ford CMP, 115" WB,1942 (Under Restoration...still) Medium sized, half fake, artillery piece project. (The 1/4 Pounder) 
|
|
|
Threaded Mode