|
|
|
|
#1
09-07-14, 07:49
|
||||
|
||||
Started making this part today. Its the bren tripod bin.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer 
|
|
#2
09-07-14, 10:14
|
||||
|
||||
|
Bin.
Jordan, when you have time, no hurry could you put up a drawing for that, looks like a nice water trap.
Kevin
__________________
2pdr Tank Hunter Universal Carrier 1942 registered 11/11/2008. 3" Mortar Universal Carrier 1943 registered 06/06/2009. 1941 Standard Mk1 stowage Carrier, Caunter camo. 1941 Standard Mk1 stowage Carrier, light stone. 10 cwt wartime mortar trailer. 1943 Mk2 Daimler Dingo. 1943 Willys MB. 1936 Vickers MG carrier No1 Mk1 CMM 985.
|
|
#3
09-07-14, 12:10
|
|||
|
|||
|
Water trap, Yes especially when it's lined with felt.
Nice job Jordan. It doesn't show in that old thread that you revived, but did you get the details for that Bren butt mount in the front floor centre. I thought I had posted details on that?
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions....
|
|
#4
09-07-14, 12:31
|
||||
|
||||
|
Kevin, see the thread on the Mk1 rifle and MG brackets. I already posted a drawing in it.
Lynn, do you mean the mount that sits up front by the drivers left foot? I've got the actual bracket. But I know there should be a kidneyished shaped plate it bolts to.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer
|
|
#5
09-07-14, 13:42
|
|||
|
|||
|
Here's a couple of pictures.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions....
|
|
#7
14-07-14, 21:07
|
|||
|
|||
|
Quote:
A question here, does this plate bolt down on another plate as I have one and it has a small square plate welded underneath at the square portion and does not sit level on the floor 
|
|
#8
18-07-14, 05:13
|
||||
|
||||
|
Dave Im not too sure on that plate. I would think it bolts down onto the hull floor and covers the hole.
Finished making the tripod bin the other day. Im getting better at welding and loving every minute of it. I also cut the felt to fit. I found using a zip disk in the hand grinder the easiest way to cut on the angles. Much easier then a knife.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer
|
 |
|
|
Hybrid Mode
