LP2 VR 2225 Build

[Dale Jordan]

Test fitting conduit and terminal box near the engine rail , can someone tell me if this looks correct I've been working off photos only as there is know detail drawings in the manuals . Also the 1" tee what wires come out of it . I'm not sure









My Shepherd crook turned up today as well

[Mick Sutherland]

Looking good Dale.
Will done

[Dale Jordan]

Picked up a nice 1935 horn the other week they are getting hard to find , and it works . I'm on two weeks holidays should have the conduit finished and air scoop fitted . I'm having a wiring harness made up next week then the drivers compartment can be finished off .. I gave the outside upper hull it's final coat of paint to blend it all together yesterday . This Time I up graded to Protec's 342 spraying enamel 30% flat khaki green No 3 much , much , better then the equipment enamel very easy to spray . It looks flat in the flesh but has an egg shell feel to it . Dale

[Dale Jordan]

My LP2 Carrier mirror bracket from Darrin turned up today . This is a real nice peace of engineering well done Darrin . I could not be happier with it , if anyone else needs one , don't miss out . Ps I'll bend my arm as per the template as my carrier is later then Darrin's . Dale

[Dale Jordan]

I've moved along a bit more with conduit layout can some one tell me if this is correct ?? before I add the loom . Dale

[hrpearce]

Hi Dale this is the only photo I have and it's not my carrier but it looks like you have it right.

[Dale Jordan]

Thanks for the photo Robert it all helps . Today Finished the conduit layout much bigger job then I thought !!! took a long time lots of bending of pipes and climbing in and out of the carrier test fitting each peace , all's good now just need to paint and add the wiring loom hope the photos help others . Dale PS can some one tell me what the two holes are for in the rear bulkhead each side just below where the engine cover goes