LP2 VR 2225 Build

[Dale Jordan]

I've moved along a bit more with conduit layout can some one tell me if this is correct ?? before I add the loom . Dale

[hrpearce]

Hi Dale this is the only photo I have and it's not my carrier but it looks like you have it right.

[Dale Jordan]

Thanks for the photo Robert it all helps . Today Finished the conduit layout much bigger job then I thought !!! took a long time lots of bending of pipes and climbing in and out of the carrier test fitting each peace , all's good now just need to paint and add the wiring loom hope the photos help others . Dale PS can some one tell me what the two holes are for in the rear bulkhead each side just below where the engine cover goes

[Darrin Wright]

Dale, those 2 holes are for the engine stabiliser rods. They go between the bell housing and the hull.
7/16" dia

[Euan McDonald]

Dale, I thought I would wait until you had painted and installed your conduit before I asked the question of what finish is the conduit done in?
I was looking at a factory pic and it looks more black than Khaki #3.
Just a thought!

[Dale Jordan]

Can some one tell me the thread size in the holes on the solenoid block on the engine rail. I can't find the correct bolt so need to clean out thread ? Dale

[Lynn Eades]

Dale the threads are going to be BA, which is why you are having trouble finding bolts to fit.
I think all the LP2 and LP2A carrier theads, smaller than 5/16 dia. are all BA. Lets see what the others say?