Hi Power 19 set

[David Dunlop]

Bruce. Thanks for the inspection report. Much appreciated.

If I am understanding the 19-Set HP correctly then, the Canadian version required two main additions to the standard 19-Set: power supply located immediately above the transceiver assembly of the 19-Set and the Amplifier itself located over the 19-Set PSU.

By comparison, the British design was a one piece integrated unit mounted above the 19-Set transceiver.

My brain tells me the British design makes more sense, but my heart tells me the Canadian design was, well…Canadian.

Wish I had lived in the Toronto area in the late 1940's and early 1950's. I vaguely recall running across an old advert in an electronics magazine from a company in the Toronto area at that time flogging complete 19-Set HP Installation sets somewhere in the $300 range.

Too soon old. Too late smart. Even later rich!


David

[Bruce Parker (RIP)]

The Canadian and British ones are not all that apart on configuration. Both have the Mk.III set and supply unit on the bottom. The British RF No.2 sits directly on top of the sender/receiver whereas the Canadian one chose a space-taking frame. The Brits used an aerial tuning unit not much bigger than a variometer but we Canadian made that big square box on the top left instead.

Originally Posted by David Dunlop

Bruce. Thanks for the inspection report. Much appreciated.

If I am understanding the 19-Set HP correctly then, the Canadian version required two main additions to the standard 19-Set: power supply located immediately above the transceiver assembly of the 19-Set and the Amplifier itself located over the 19-Set PSU.

By comparison, the British design was a one piece integrated unit mounted above the 19-Set transceiver.

My brain tells me the British design makes more sense, but my heart tells me the Canadian design was, well…Canadian.

Wish I had lived in the Toronto area in the late 1940's and early 1950's. I vaguely recall running across an old advert in an electronics magazine from a company in the Toronto area at that time flogging complete 19-Set HP Installation sets somewhere in the $300 range.

Too soon old. Too late smart. Even later rich!


David

[David Dunlop]

Thanks, Bruce. Now the light bulb is fully lit. Much appreciated with the shorter days setting in.

David

[Bruce MacMillan]

That big square box on the upper left in Bruce's photo is the actual amplifier itself. The other box beside it is only the power supply. The Canadian set had more power output compared to the Brit's unit but like I said it was quite bit heavier and loved to drain batteries. Somewhere in my files I have a memo from Ottawa telling the Canadian Army Overseas that the amp will not be deployed.

The aerial tuning for the Canuck amp when transmitting was built into the amplifier box itself but you will notice that the variometer is mounted on the right. It was still needed for receiving. You needed two aerials, one for transmit and one for receive. The variometer also had a relay assembly to protect the 19 set when transmitting.

These were never used during WW2 but there is a painting in the Canadian War Museum by a war artist during the Korean war and in the background of one painting you can see the amplifier section. I suspect the amps were used then.

[David Dunlop]

Based on when the Canadian HP setup reached maturity, was it designed for use only with the Mk III Canadian 19-Set? By comparison, it seems the British version may have been compatible with both the Mk II and Mk III, both British and Canadian.

David

[Bruce MacMillan]

The Canadian amplifier was designed to work with both British & Canadian MKII & MKIII sets (this would also include the MKII sets made in the US and sets made in Australia).

[David Dunlop]

Thanks, Bruce.