How To: C15a Wire-3 restoration

[Jordan Baker]

I'd rather overkill it with the spot welds then under do it. On my original the welds were every couple of inches but it also varied a bit.

As for going around the corners it was really simple. The 18ga simply followed the bend of the frame. If I let it go it would spring back. But with clamps I could easily hold and pull it in tight.

I decided to smooth out my welds as I probably over did it with the heat a bit to get good penetration into the frame. On my original only a few of the spot welds were visible and that was usualy from the rust forming between the sheet and frame and pushing the sheet out.