|
|
#16
18-09-15, 21:10
|
||||
|
||||
Drill and prep all holes first,,,, bolt the plate on and check alignment, remove every other bolt and replace with a rivet... Allow to cool and repeat with the remaining bolts. Problem with using clamps is they vibrate loose and you end up with slack rivets or miss alignment issues, fine if your doing maybe one rivet, but not say an entire side plate on a carrier.
http://youtu.be/NKBXa9PaSZM I have done a couple
__________________
is mos redintegro __5th Div___46th Div__ 1942 Ford Universal Carrier No.3 MkI* Lower Hull No. 10131 War Department CT54508 (SOLD) 1944 Ford Universal Carrier MkII* (under restoration). 1944 Morris C8 radio body (under restoration). Last edited by RichardT10829; 18-09-15 at 21:53. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| For Sale: Universal Bren Carrier, Loyd Carrier Models | K713 | For Sale Or Wanted | 1 | 21-10-12 12:48 |
| front armour steering box rivets | RichardT10829 | The Carrier Forum | 20 | 13-12-11 20:19 |
| Copper Split rivets | Jordan Baker | The Restoration Forum | 7 | 03-02-09 15:22 |
| Rivets-what to do? | Ralph Volkert | The Restoration Forum | 7 | 21-05-08 05:44 |
| Bren Gun Carrier/Carrier LP2A Steering Wheel on eBay | Hanno Spoelstra | For Sale Or Wanted | 0 | 29-05-05 22:39 |
Threaded Mode