|
|
#25
12-10-15, 05:17
|
||||
|
||||
Hi Matt, your carrier is looking good! Haste certainly can make waste and I can tell you from experience. I would not grind the floor weld either as they are never seen. When ever I have done welding on carriers I do cut back where I can to have clean steel to weld to and have always run my welder quite hot and always used gas and not gasless. I just don't think you get enough heat out of the small portable migs but your floor repair looks very good. Keep up the good work and pics.
Colin. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Restoration of Hull 731- Carrier, MG (Aust) Mortar Carrying | Darrin Wright | The Restoration Forum | 359 | 25-04-15 07:30 |
| Carrier hull | Mick Sutherland | The Carrier Forum | 1 | 17-07-13 20:33 |
| Hull # | gary_bath_jr | The Carrier Forum | 5 | 12-07-10 21:31 |
| Welded hull | martyn | The Carrier Forum | 14 | 15-03-10 14:02 |
| UC Hull | Richard Coutts-Smith | The Carrier Forum | 14 | 08-04-08 02:25 |
Threaded Mode