good bye C60 hello ford fat

[Alex van de Wetering]

If you have the measurements please do dig them out it could be fun to see how much they vary.

Niels, Silvain, the FAT.....or actually two FATs, I measured, lacked most of rear body and lids. Attached is a pic of the side, rearmost lid. The other pic shows the side bin right above the rear wheel; sadly the lid was missing.
The measuring aid--> large white and black blocks are 5cmx5cm, small blocks are 1cmx1cm

By the way, both trucks were for sale as a job lot, with one very good chassis. They might still be available(?). Peter Geert Hommes was the broker for the trucks.

Alex

[Alex van de Wetering]

Attached are pics of the doors, inside and outside. The drawing shows measurements in cm (and just noticed some are in mm)


Alex

[Alex van de Wetering]

More pics of the doors

[Alex van de Wetering]

This is what all I have on the doors.

Alex

[Harlé Sylvain]

hello
And thank you very much for all this precious mesurements! And in metric!

After what I foud on internet they used recuted Ford A door hinge , What about the hatch, is it also reused from an other wehicle or only cmp?

I see the truck that you pictured was painted in white inside , that's also the case of mine, is it original ,or post war?

What about the lids lock , are they standart, or will I have to rebuilt them?

Thank you again,
Sylvain

[Harlé Sylvain]

Hello
Here is a few pictures of my wok on the FAT
Fast all the tube are complete rusted , there is wood inside.
So it will have a complete new tubular structure.

Cheers
Sylvain

[Harlé Sylvain]

Hello
just an other question ,What could be fixed here behind the passenger, someting round but???

regards
Sylvain