Chev 6 Seater Utility

[Wayne Henderson]

Blasted the chassis and it all went back together well. New spring bushes, a king pin kit from the US, all the original side steps, original wheel bearings and a partial engine rebuild. Gearbox was good and like new inside.
Replaced all brake and fuel lines, new wheel cyl kits and cleaned up the brake parts.

Fitted the front cab and roof to the rear section, bolted at the front nailed at the back, not a big fan of how this was done and it is the weakest part of the body so I made a few unseen improvements in the join.

Starting to look like a truck at last.

You can now see the fuel tank and filler cutouts in the floor.