Lynx scout car wiring problems (Ford)

[Mike K]

Rick

I think you have misunderstood the circuit . If you study the wiring diagram, the coil 4 Volts feed comes off the larger resistor . The smaller resistors feed the instruments . Mike

[Colin Alford]

Rick,

I will echo Mike's comment that I think you previously misunderstood which components were performing which task on the Circuit Breaker/Ignition Resistor/Voltage Divider assembly.

I think if you have a good study on the newly provided wiring diagrams that it should make sense (I can send higher resolution images if you would like).

I have also sorted out the question of the mounting bolt providing a path to ground and therefore a short circuit. The mounting bolt is designed to provide the ground and therefore make the Voltage Divider work! I really had no idea how this functioned until I googled "Voltage Divider"

See:
https://en.wikipedia.org/wiki/Voltage_divider

[Peter Duggan]

Rick,

Thanks for raising this question about the mounting of the circuit breaker assembly. I was mistaken about how it functioned and how it should be mounted.

Colin, Mike and Rob,

Thanks for sharing your time and knowledge. These are the benefits that I was seeking when I first joined this forum. A great group of people.

Thanks again, Peter

[lynx42]

Thank you Peter, Rob, Mike and Colin. We're getting somewhere. I was completely stumped at the start but now seem to understand a bit better.(??)

I have sent you a PM Colin, for better resolution copies of the SC-F3 wiring system.

The early Lynx manual Sc-F1 and F2,(mine) is hard to understand and as well, all wires are BLACK and not numbered.

Thanks again, I knew MLU members would come up with the answers.
Regards Rick.

[lynx42]

Next question, what is with all the condensers on everything and filters as well. Is it necessary to have every one or can the vehicle operate without some of them?

Can I use any old (new) condenser or do they have a rated action?

I guess that they are there to cut down radio interference etc, so are they really necessary if I am not using a working WWII radio? I have a No.11 fitted but it is only there for looks.

Regards Rick.

[Lynn Eades]

You can leave them all off Rick

[rob love]

Colin

Good information on the voltage divider. I have learned something new today. When I get a chance I'll have to check the Lynx and make sure it was wired properly.

Old dog now has a new trick.

[Tony Wheeler]

Originally Posted by Mike Kelly

If you study the wiring diagram, the coil 4 Volts feed comes off the larger resistor . The smaller resistors feed the instruments .

Exactly.

Lynx resister unit 013.jpg

I notice one wiring diagram is for ammeter and the other is for battery condition indicator (ie. voltmeter). It's optional of course but something to be aware of when wiring up.