|
|
#32
29-11-04, 07:55
|
||||
|
||||
HUP shock links
Rob: Here's a link to a page at Vintage Auto Parts with a selection of Chevy shock links - the third version look like they might be usable, but one would have to enquire about the length and spindle dimensions. I hope they might be usable for the front links that I need. The manual says the rear links are something 9.5" and the front are 8" (or is it 8.5" and 9" - manual at workshop, have to check) - I have some rear shocks with the links attached I got from Lorne Ertle, and I could take a snap or two of them tomorrow if you like and take some measurements.
http://www.vapinc.com/chevy/Shock%20Parts/main.html Speaking of measurements, I was wondering if you could take some measurement of your intact left hand bumper mount and send them along so I can eventually figure out some sort of fabrication for my butchered mounts.
__________________
Member: Prairie Command, Ex-Military Land Rover Association 2110, MVPA 29055 ’45 Chevrolet C8A CMP HUP “Staff Car ”, ’82 Land Rover Series III, 109" ex-MoD, ’80 Honda CX500D, ’48 Ferguson TE20 
|
|
|
Threaded Mode