2016 at the Hammond Barn

[Bob Carriere]

Totally rewired my C15a with a repro wiring harness made by Phil Waterman.

It's a lot of work.....did a final check with Grant today....found one wire out of place on the HAM-metre.

Reconnected the battery..... waited....no fizzz....no phiittzzz...no smoke.... so tried all the lights.... worked fine.... turned the new ignition key ...engine fired up micely and even the HAM-metre was working properly..... and this is a 12 volt conversion with a new alternator.

Brake lights did not work but we tracked it down to a defective brake switch....

Very pleased with the result and the harness from Phil was a delight to work with.

One more step closer to getting a safety for the road.

Cheers