|
|
#11
23-05-16, 00:37
|
|||
|
|||
The Tie rod on my C8 was bent and the ends were cracked. I wasn't really comfortable with welding these cracks, so I had a replacement tie rod fabricated at a machine shop. New Tie rod ends came from Jim Carter. I re-used the old clamps, but replaced the bolts.
One of the pictures attached shows one clamp after a Molasses bath (2-3weeks) and the second clamp (the shiny one) after 15 minutes with the wire wheel on an angle grinder. I also had the ball on the steering arm rewelded at the local blacksmith.....but somehow I can't find the picture of the end result  Alex
__________________
Chevrolet C8 cab 11 FFW BSA Folding Bicycle Last edited by Alex van de Wetering; 23-05-16 at 00:43. 
|
|
|
Threaded Mode