Unknown part

[bigbryan]

Hi, I picked these up today, however, I am unsure if they are what I think they are.

[Ben]

If you think they're frames for the armoured glass, then yes they are.

Nice find, they're usually broken.

Ben

[Petr Brezina]

Very nice find!

[Lynn Eades]

Bryan, Have they got a part number on them?
They should have 688-3 and 688-4 for your carrier.
If they have TL**** or CTL**** They are most likely not going to fit.

[bigbryan]

HI Lynn ,i cant find any numbers on them. A mate picked them up of another bloke who said they were of a bren gun carrier. How he got them im not sure.
There is 3 of them, i wasn't sure, but was guessing thats what they were .Bryan

[Lynn Eades]

Bryan, as Ben said, they are definitely carrier, but I think riveted carrier. The riveted carrier takes thinner glass than the LP2. About 5mm verses 6mm. If they are wrong, I can't help sorry.(if they fit, use them) They are handed. Two the same and one different per carrier. Do you have your carrier back? How is progress on it?

[bigbryan]

HI Lynn, yes there is 2 the same 1 different in the hole department. I measured the gap for the glass and it is 5mm. If they fit i will use them.
I haven't seen it since December but it was progressing, will have to go visit. Bryan