Info needed: M38a1 blinker issues

[rob love]

Do you have the solid state flasher system? If so there are a couple of possibilities.

The flasher will stop flashing when it gets too hot. When this happens the end is near for the flasher unit.

The flasher will also just stay on solid if there is a short in one of the 4 wires that it feeds. Common spots are places in the harness where those little metal frame clips secure the harness to the frame. There was a modification to the M151A2 Jeeps to prevent flasher failure the short would cause by installing a fuse on the power in wire (460/461).

The solid state flashers are kind of pricey. They can easily be replaced with a normal 2 prong flasher (in 24 volt of course) if need be.

[army brat]

Originally Posted by rob love

Do you have the solid state flasher system? If so there are a couple of possibilities.

The flasher will stop flashing when it gets too hot. When this happens the end is near for the flasher unit.

The flasher will also just stay on solid if there is a short in one of the 4 wires that it feeds. Common spots are places in the harness where those little metal frame clips secure the harness to the frame. There was a modification to the M151A2 Jeeps to prevent flasher failure the short would cause by installing a fuse on the power in wire (460/461).

The solid state flashers are kind of pricey. They can easily be replaced with a normal 2 prong flasher (in 24 volt of course) if need be.

Yes it is the solid state flasher. I will have a closer look at the harness and check it with an ohms meter and see if its open or not.

Thanks for the help. Ill let you know what I find

[rob love]

My money says it may be a short to ground, or else heat/tired flasher.

They will burn the contacts within the control arm as well.

Disconnect the harness from the signal switch and test the resistance on wires 22-460 and 22-461. One of those is usually the culprit. You can also check 460 and 461, but they are usually OK.

Wiggle the frame clips slightly against the harness while someone is watching the ohmmeter and you may find the problem.

If you want to try a 24 volt commercial flasher, splice it into the A and B wires instead of the solid state flasher. Leave C wire alone as it is not used on a flasher. Resist the temptation to hook C to the third terminal of a flasher in the case of a 3 prong. C is a ground, and the third terminal is the little light on the arm of the older flashers.

[army brat]

Hi Rob

Thanks for all the great information, its been a great help! I have not had a chance to check the wiring for shorts yet. I will have a minion to help me Saturday to do this chore.
Fingers crossed!
Cheers