|
|
#22
14-01-17, 03:22
|
|||
|
|||
Creative solution
Guys,
I went to a local machinist, Tom Wiltse, who has bailed me out on previous occasions. My request was to weld a spacer on the inside of the pulley. He wasn't keen about the idea and proposed machining the pulley sheaves from the inside for half it's width, then machining a two step spacer to the right length and press it into place. Worked like a charm. The change isn't even visible, and the pulley alignment is spot on. Now to move onto the next challenge. Peter 2017-01-12 15.50.26 (2).jpg 2017-01-12 15.50.30 (2).jpg 2017-01-13 08.18.29 (2).jpg 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lynx Hull number? | James Gosling | The Armour Forum | 3 | 17-08-15 09:28 |
| At last here are some photos NZ LP hull | Lew Skelton | The Carrier Forum | 12 | 29-04-11 11:22 |
| Hull # | gary_bath_jr | The Carrier Forum | 5 | 12-07-10 21:31 |
| Welded hull | martyn | The Carrier Forum | 14 | 15-03-10 14:02 |
| UC Hull | Richard Coutts-Smith | The Carrier Forum | 14 | 08-04-08 02:25 |
Threaded Mode