|
|
#33
29-06-17, 02:37
|
||||
|
||||
Fitted on the two sides today. I discovered I had some issues with the wheel wells dropping a bit when the original sides were cut off. This left me with a bit of a gap to lclose. I ended up using a floor jack and ratchet strap. Using the strap to hold the jack tight to the box frame I then jacked it up with a block of wood. This pressed the wheel well in tight to the side panel and I could get some good tac welds in.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1944 C-15A-Wire-5 Restoration | RichCam | The Restoration Forum | 706 | 18-05-23 03:43 |
| Sold: 1944 Chev C15A Wire-3 | Don Dingwall | For Sale Or Wanted | 11 | 03-04-15 00:26 |
| What was once 2, is now 1. (C15A-Wire-5) | RichCam | The Softskin Forum | 3 | 30-12-11 23:49 |
| photos needed for c15a wire 3 van body | jason meade | The Softskin Forum | 5 | 10-08-11 07:29 |
| Wire loom for C15A Cab13 | Jordan Baker | The Restoration Forum | 19 | 28-08-06 04:42 |
Threaded Mode