|
|
|
|
#1
03-08-17, 09:24
|
||||
|
||||
Barry Churcher made a bracket to fit the more common master cylinder to a CMP. May be a solution for others as well.
HTH, Hanno
__________________
Regards, Hanno -------------------------- 
|
|
#2
03-08-17, 20:56
|
||||
|
||||
|
I had the same problem with my HUP, I did think about having the master cylinder it lined but in the end I bought a new one fro Rockauto in the US. Its slightly different in that it has two bolt holes that go through the chassis and you need to make a couple of spacers but mine already had the holes. The part number is MCA4555.
Jon
__________________
1950 Land Rover series 1 1967 Land Rover series 2A LWB 1986 Land Rover series 3 SWB 1938 DKW SB200 1944 DKW NZ350-1 1967 Ural K750 sidecar outfit 1944 VW Kubelwagen KDF82 1942 Steyr 1500A 1944 Morris C8A 1943 Chevrolet CMP8A HUP? 194? Bedford QL
|
|
#3
06-08-18, 23:32
|
|||
|
|||
|
Comments on installing kits to sleeved master cylinders http://www.mapleleafup.net/forums/sh...780#post252780
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ford Master Cylinder | Phil Waterman | Parts/Sources/Prices | 5 | 27-09-15 13:36 |
| C60X Master Cylinder rebuild kit | Gunner | Parts/Sources/Prices | 10 | 27-02-11 16:10 |
| Master cylinder check and top up | OttawaValleyGuy | Post-war Military Vehicles | 3 | 11-11-10 10:49 |
| Chevrolet Master Cylinder picture | Ganmain Tony | Parts/Sources/Prices | 9 | 10-06-10 20:40 |
| Ford Master Cylinder | Eric Szalanda | Parts/Sources/Prices | 1 | 03-08-09 11:55 |
Hybrid Mode
