![]() |
|
|
|
#1
|
||||
|
||||
|
I sharpen the valve surface
Sharpens the valve surface on the engine block With the original work tools We have all the tools and experience.
__________________
Itzik Merkado 4x6zh |
|
#2
|
|||
|
|||
|
Installed Drums and Shafts - rear axle, and rear BOGIE.
and some othe preperations for next parts to be install,
__________________
4x1om Israel Berko
|
|
#3
|
|||
|
|||
|
Bren Carrier Engine
__________________
4x1om Israel Berko
|
|
#4
|
|||
|
|||
|
Where do i found a full VALVE ASSEMBLY - RADIATOR PRESSURE
__________________
4x1om Israel Berko
|
|
#5
|
|||
|
|||
|
Very hard to find.... I have been looking for one for my carrier for some 4 years with no luck. If you find an extra, please let me know!
|
|
#6
|
|||
|
|||
|
Here's one way forward, and much easier to check the water level.
You need a four pound cap (no higher pressure) as the radiators cant handle it. I used a Morris Minor one. and a neck off ebay. Then you have to have the threaded part made and welded to the neck.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... |
|
#7
|
|||
|
|||
|
thanks Lynn
Do you have dimension of the threaded part exact thread that will fit the hole on top of radiator? Best Regards Israel
__________________
4x1om Israel Berko
|
![]() |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| For Sale: Bren Carrier Seat Backs (Restoration Req'd) | B. Harris | For Sale Or Wanted | 2 | 08-02-16 16:33 |
| Buried Mk 1 Bren carrier restoration | derk derin | The Carrier Forum | 47 | 30-01-10 19:27 |
| Bren Carrier Restoration | delgriffith | The Restoration Forum | 0 | 23-11-06 02:40 |
| Bren Gun Carrier/Carrier LP2A Steering Wheel on eBay | Hanno Spoelstra | For Sale Or Wanted | 0 | 29-05-05 23:39 |
| Carrier Restoration | Richard Notton | The Carrier Forum | 9 | 01-02-04 23:06 |