|
|
|
|
#1
15-01-18, 00:19
|
|||
|
|||
Thanks, Chris. Much appreciated. PM me if you need my address.
I was wondering about that broken screw as I could see they were visible inside the clips, but a screwdriver would have to be forced into the clip to access the screw, which struck me as a very unfriendly thing to attempt to do to the clips. You have now confirmed my suspicion that the back door to the Connector Plug is the best avenue of approach. David 
|
|
#2
15-01-18, 07:54
|
|||
|
|||
|
When I restored my Canadian Marconi CM11 I noticed it used the same connectors. Males were on the cabinet back & females on the equipment.
Jerry Proc restored the same equipment on HMCS Haida and may have or know of where spares may be on your side of the pond. http://www.jproc.ca/ Last edited by Bruce MacMillan; 15-01-18 at 18:54.
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Canadian staff car wireless: World War 2 Canadian R103 Receiver Demo | Mike K | The Wireless Forum | 5 | 24-07-16 15:20 |
| Found: CMP Wireless body project | Jim Burrill | For Sale Or Wanted | 7 | 05-04-15 00:02 |
| Canadian dehavilland mosquito restoration project | David Dunlop | WW2 Military History & Equipment | 9 | 10-07-14 00:51 |
| Canadian project | David Ellery | The Carrier Forum | 9 | 28-04-07 01:36 |
| FOR SALE/TRADE: 1944 CHOREHORSE PROJECT for Signal Corps Wireless Power Unit Project | Alain | For Sale Or Wanted | 1 | 21-02-07 00:11 |
Hybrid Mode
