Early M38A1 CDN Info

[Les Kovacs]

Hi Rob....thanks for the reply.....the jeep looks and drives good because of my much too frequent cry for help on MLU and your eagerness to help me out.

The engine pics were taken this summer probably about two week after I purchased the jeep. Since that time I have removed the air (rad) hose and replaced it with a proper accordion type hose from Brian Asbury. The upper fuel filter was also taken out as I have plumbed one before the fuel pump directly below the radiator.....I also did not know that the glass bowl was a filter....I just though that it was a sediment bowl and I wanted something finer.

Right now I have gotten back my 3 row re-cored rad and I am in the process of painting it....as well as replacing the bellcrank hardware as per your help in previous posts before the rad is reinstalled.

I am searching for an upper FN C1 clip as well as a lower butt cradle.....any suggestions as where to look?

Regards,

lesk