|
|
#33
13-04-18, 01:51
|
||||
|
||||
I also managed to get the NOS shifter forks installed in the top this afternoon. All went smoothly even without the special tool for depressing the little ball as the shaft goes in. I used a flat screwdriver and it worked really well. It did take a while until I managed to get the three forks in the correct position. The manual doesn’t really say much on this step. With that I did some trial fitting of it on the main case and all lined up. Next up is cleaning up my stick shifters.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1944 C-15A-Wire-5 Restoration | RichCam | The Restoration Forum | 706 | 18-05-23 02:43 |
| Sold: 1944 Chev C15A Wire-3 | Don Dingwall | For Sale Or Wanted | 11 | 02-04-15 23:26 |
| What was once 2, is now 1. (C15A-Wire-5) | RichCam | The Softskin Forum | 3 | 30-12-11 22:49 |
| photos needed for c15a wire 3 van body | jason meade | The Softskin Forum | 5 | 10-08-11 06:29 |
| Wire loom for C15A Cab13 | Jordan Baker | The Restoration Forum | 19 | 28-08-06 03:42 |
Threaded Mode